Removal And Installation

TRANSFER ASSEMBLY


VK56VD : Removal and Installation


REMOVAL
1. Remove transmission assembly from the vehicle. Exploded View Removal And Installation, "VK56VD (AWD) : Removal and
Installation".
2. Remove transfer air breather hose.
3. Remove rear engine mounting member and engine mounting insulator with power tool. Exploded View Removal And Installation, "AWD : Removal and Installation".
4. Support transfer assembly with a jack.
5. Remove transfer mounting bolts with power tool and separate transfer from transmission.

CAUTION:
Secure transfer assembly and transmission assembly to a jack.

INSTALLATION
Note the following, and install in the reverse order of removal.





- When installing the transfer to the transmission, install the mounting bolts following the standard below, tighten bolts to the specified torque.





- When installing transfer air breather hose, make sure there are no pinched or restricted areas on the transfer air breather hose caused by bending or winding.





- Set transfer air breather hose with the paint mark (A) facing upward.





- Be sure to insert air breather hose (1) of transmission side to air breather tube until hose end reaches the tube bend R portion.





- Be sure to insert air breather hose (1) of transfer side to air breather tube (2) until hose end reaches the tube bend R portion.





- Be sure to fix air breather hose in (A) parts of transmission and transfer.
- After the installation, check the fluid level, fluid leakage and the A/T positions. Inspection.