With a Sunroof Removal and Installation

HEADLINING


SUNROOF : Removal and Installation


REMOVAL
1. Remove front body side welt (LH/RH). Removal and Installation.
2. Remove front pillar garnish (LH/RH). Removal and Installation.





3. Remove antenna feeder securing clips with a remover tool after removing front pillar garnish (LH), then disconnect antenna feeder connectors (A).

Circle : Clip






4. Remove front roof finisher mounting metal clips and pawls, and then remove front roof finisher (1).

Triangle : Pawl
Square : Metal Clip

5. Remove sun visor assembly (LH/RH).
- Remove sun visor cover.
- Remove sun visor assembly mounting screws.
- Disconnect vanity mirror lamp harness connectors.





6. Rotate 45 degrees and remove sun visor holder (1) (LH/RH).





7. Remove mounting plastic clips (A) using a screwdriver (B) of front and rear assistance grips (1), and then remove assist grips.
8. Remove rear seat cushion and seatback. Removal and Installation.
9. Remove front kicking plate inner, center pillar lower garnish, center pillar upper garnish, rear kicking plate inner, rear wheelhouse garnish, rear pillar finisher. Removal and Installation.





10. Disconnect antenna feeder connectors (A) of antenna amplifier and sub-antenna feeder after removing rear pillar finisher (LH), and then remove antenna feeder securing clip (B) with a remover tool.

Circle : Clip

11. Remove passenger seat assembly. Removal and Installation.
12. With a remover tool, remove body side mounting plastic clip from rear end of headlining.





13. Pull down roof console assembly and disengage metal clips (B) and dual lock fastener (A).

CAUTION:
Roof console assembly is crimped from back of headlining.
Remove it by disengaging the crimped area of back of roof console assembly after removing headlining from the vehicle.

Square : Metal Clip





14. Remove headlining from rear door left opening.

CAUTION:
- When removing, 2 workers are required. (1 for the front and rear of headlining)
- Cover center console finisher upper surface with a shop cloth to prevent it from being damaged.
- Never bend headlining when removing.
15. Remove the following parts after removing headlining.
- Roof console assembly. With a Sunroof Exploded View.
- Personal lamp (LH/RH). Removal and Installation.
- Map lamp assembly. Removal and Installation.
- Roof harness assembly.
- Antenna feeder assembly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Install headlining assembly after inserting clips to clip holder of headlining rear end.
- Never bend headlining when installing.