Removal and Installation

ENGINE ROOM COVER


Removal and Installation


REMOVAL

CAUTION:
Never damage or scratch cover when installing or removing.
- Removal and Installation for removal and installation of engine cover.
- Component Removal and Installation for removal and installation of air duct (inlet).
- Remove the washer tank cap before removing the engine room cover (RH).
- Remove the engine room covers (RH and LH) by lifting the clipped point using a clip driver.
- Major parts and inspection points under each cover are as follows: (numbered as in the figure)
1. Upper side of engine assembly
2. Battery, relay box
3. Power steering fluid reservoir tank, engine coolant reservoir tank, relay box
4. Engine assembly front side, drive belts, cooling fan
5. Mass air flow sensor, air cleaner case
6. Brake master cylinder, brake booster

INSTALLATION
Install in the reverse order of removal.