Removal and Replacement

OIL PUMP


Removal and Installation


REMOVAL
1. Remove oil pan (lower) and oil strainer. (2WD models) or Component (AWD models).
2. Remove front timing chain case and timing chain (primary). Component.
3. Remove oil pump assembly.

INSTALLATION

CAUTION:
Before installation, apply new engine oil to the parts as instructed in the figure.
Note the following, and install in the reverse order of removal.
- When installing, align crankshaft flat faces with oil pump inner rotor flat faces.

INSPECTION AFTER INSTALLATION
1. Check the engine oil level. Procedures.
2. Start the engine, and check there is no leakage of engine oil.
3. Stop the engine and wait for 10 minutes.
4. Check the engine oil level and adjust the level. Procedures.