Removal and Installation

PARKING BRAKE CONTROL


Removal and Installation


REMOVAL
1. Release parking brake.
2. Remove rear tires from vehicle with power tool.
3. Remove instrument driver lower panel. Instrument Panel.
4. Disconnect parking brake switch connector.
5. Remove adjusting nut and loosen front cable.
6. Remove device assembly mounting nuts and remove device assembly from vehicle.
7. Remove center console. Locations.
8. Separate rear cable from front cable, remove front cable from vehicle.
9. Remove heat insulator of the exhaust center muffler from vehicle.
10. Remove parking brake shoe, and remove rear cable from toggle lever. Removal and Installation.
11. Remove rear cable mounting bolts and nuts, pull out rear cable from vehicle.

INSTALLATION
1. Install in the reverse order of the removal. Component for tightening torque.

CAUTION:
Do not reuse adjusting nut.
2. Adjust parking brake. Testing and Inspection.