A/T Shift Selector Removal and Installation

SHIFT CONTROL SYSTEM


A/T Shift Selector Removal and Installation


A/T SHIFT SELECTOR COMPONENTS (2WD MODELS)





REMOVAL

CAUTION:
Make sure that parking brake is applied before removal/installation.
1. Move selector lever to "N" position.





2. Remove knob cover (1) below selector lever downward.
3. Pull lock pin (3) out of selector lever knob (2).
4. Remove selector lever knob.
5. Remove cup holder, switch finisher, cluster lid C and A/T console finisher. Refer to Instrument Panel
6. Remove center console. Refer to Instrument Panel.
7. Disconnect A/T shift selector connector.
8. Remove A/T shift selector assembly.

INSTALLATION
Note the following, and install in the reverse order of removal.
- After installation is completed, adjust and check A/T position. Refer to 5AT RE5R05A and 5AT RE5R05A.

A/T SHIFT SELECTOR COMPONENTS (AWD MODELS)





REMOVAL

CAUTION:
Make sure that parking brake is applied before removal/installation.
1. Disconnect lower lever of A/T shift selector and control rod.
2. Move selector lever to "N" position.





3. Remove knob cover (1) below selector lever downward.
4. Pull lock pin (3) out of selector lever knob (2).
5. Remove selector lever knob.
6. Remove cup holder, switch finisher, cluster lid C and A/T console finisher. Refer to Instrument Panel.
7. Remove center console. Refer to Instrument Panel.
8. Disconnect A/T shift selector connector.
9. Move selector lever to "P" position.
10. Move driver side seat to the end.





11. Remove one of floor carpet attachment clips (1).
12. Remove A/T shift selector assembly mounting dolts.





13. Lift A/T shift selector assembly (1). Then slide to the right till touching floor carpet.
14. Pull A/T shift selector assembly (1) out in the right-slanting direction while pressing to the right.






INSTALLATION
Note the following, and install in the reverse order of removal.

NOTE:
Bend A/T shift selector assembly (1) to vehicle, then insert lower lever (2) to the rear of vehicle.





- After installation is completed, adjust and check A/T position. Refer to 5AT RE5R05A and 5AT RE5R05A.