Removal and Installation

OIL PUMP


Removal and Installation


REMOVAL
1. Remove engine assembly from vehicle. Refer to Component.
2. Remove front cover. Refer to Exploded View.





3. Remove oil pump drive spacer.
- Set bolts in the two bolt holes [M6 � pitch 1.0 mm (0.039 in)]
on the front surface. Using suitable puller, pull oil pump drive spacer off from crankshaft.

NOTE:
The dimension between the centers of the two bolt holes is 33 mm (1.30 in). In the figure, a commercial steering puller is used.
4. Remove oil pump.

INSTALLATION
1. Install the oil pump.
2. Install oil pump drive spacer as follows:





a. Insert oil pump drive spacer according to the directions of crankshaft key and the two flat surfaces of oil pump inner rotor.
- If the positional relationship does not allow the insertion, rotate oil pump inner rotor with a finger to allow spacer.
b. After confirming that the position of each part is in correct condition to allow for spacer, force fit spacer by lightly tapping with plastic hammer until it contacts and does not go further.
3. Install in the reverse order of removal after this step.

INSPECTION AFTER INSTALLATION
1. Check the engine oil level. Refer to Testing and Inspection.
2. Start engine, and check there is no leakage of engine oil.
3. Stop engine and wait for 15 minutes.
4. Check the engine oil level and adjust engine oil. Refer to Testing and Inspection.