Cowl Moulding / Trim: Service and Repair

COWL TOP


Removal and Installation


REMOVAL
1. Remove front wiper arm (LH/RH) from vehicle. Refer to Service and Repair.
2. Remove engine room cover (LH/RH), battery cover and brake master cylinder cover.
- VQ35HR engine models: Refer to Exploded View.
- VK45DE engine models: Refer to Component.
3. Remove cowl top seal rubber.
4. Remove cowl top cover mounting clips (LH/RH).





5. Plastic pawl A is pull up and cowl top cover RH (2) is removed ahead of vehicles.
6. Plastic pawl B is push down and cowl top cover LH (1) is removed ahead of vehicles.

INSTALLATION
Note the following, and install in the reverse order of removal.





- Install cowl top cover LH (1) with C (pin from front windshield glass) aligned with concave part.
- Slide the pin while aligning with the concave part of E.





- Engage the joint of plastic pawl of A with D, and then assemble cowl top covers LH (1) and RH (2).

CAUTION:
After installing, perform adjustment of wiper arm. Refer to Service and Repair.