Rear Parcel Shelf Finisher

REAR PARCEL SHELF FINISHER


Removal and Installation


REMOVAL
1. Remove rear seatback and rear seat cushion. Refer to Removal and Installation.
2. Remove rear seat belt floor anchor bolt and rear seat belt shoulder anchor bolt. Refer to Rear Seat Belt.
3. Disengage child anchor cover front pawls, and then pull out child anchor cover (LH/RH center) toward front of vehicle. (Models with rear window sunshade)
4. Remove rear kicking plate inner, rear wheelhouse garnish, rear pillar finisher. Refer to Service and Repair.





5. Disconnect high-mounted stop lamp harness connector from front side of rear parcel shelf finisher. (Models with rear window sunshade)
6. Remove rear parcel shelf finisher mounting clip using a clip clamp remover.
7. Remove the following parts after removing rear parcel shelf finisher.
- High-mounted stop lamp
- High-mounted stop lamp harness
- Rear speaker grille
- Woofer grille (Models with woofer)

INSTALLATION
Install in the reverse order of removal.

CAUTION:
When installing rear parcel shelf finisher, check that clips are securely fitted in panel holes on body, and then press them in.