Headlamp Bulb: Service and Repair

HEADLAMP (FOR USA) - XENON TYPE -


Bulb Replacement


CAUTION:
- Disconnect the battery negative terminal or remove the fuse.
- Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it.
Never touch bulb by hand while it is lit or right after being turned off.
- Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.

HEADLAMP (INNER) HIGH BEAM
1. Remove air cleaner case when replacing bulb LH. Refer to Removal and Installation (VQ35HR) or Removal and Installation (VK45DE).
2. Remove washer tank inlet when replacing bulb RH. Refer to Service and Repair.
3. Turn plastic cap counterclockwise and unlock it.
4. Turn bulb socket counterclockwise and unlock it.
5. Disconnect connector, and remove bulb.

Headlamp (inner) high beam : 12V - 60W (HB3)


HEADLAMP (OUTER) LOW BEAM
1. Remove fender protector (front). Refer to Fender Protector.
2. Turn plastic cap counterclockwise and unlock it.





3. Turn bulb socket (1) counterclockwise and unlock it.
4. Unlock retaining spring and remove bulb from headlamp.

Headlamp (outer) low beam : 12V - 35W (D2S)


PARKING LAMP
1. Turn bulb socket counterclockwise and unlock it.
2. Remove bulb from its socket.

Parking lamp : 12V - 5W


FRONT TURN SIGNAL LAMP
1. Remove washer tank inlet when replacing bulb RH. Refer to Service and Repair.
2. Remove air cleaner case when replacing bulb LH. Refer to Removal and Installation (VQ35HR) or Removal and Installation (VK45DE).
3. Turn bulb socket counterclockwise and unlock it.
4. Remove bulb from its socket.

Front turn signal lamp : 12V - 21W (amber)


FRONT SIDE MARKER LAMP
1. Turn off the fender protector (front) to obtain work space between the fender protector and fender.
2. Turn bulb socket counterclockwise and unlock it.
3. Remove bulb from its socket.

Front side marker lamp : 12V - 5W


CAUTION:
After installing bulb, be sure to install plastic cap and bulb socket securely to insure watertightness.