CAN Communication Line

CAN Communication Line

DIAGNOSTIC PROCEDURE
^ Check the following if "CAN COMM CIRCUIT [U1000]" is detected in self-diagnosis results of CONSULT-III.

1.CHECK CAN COMMUNICATION CIRCUIT

With CONSULT-III
1. Turn ignition switch "ON" and start engine.
2. Select "SELF-DIAG RESULTS" mode for "ALL MODE AWD/4WD" with in CONSULT-III.
3. Perform the self-diagnosis.
Is the "CAN COMM CIRCUIT [U1000]" displayed?
YES >> Print out CONSULT-III screen and go to LAN-29, "CAN System Specification Chart". CAN System Specification Chart
NO >> INSPECTION END