Work Support (Levelizer Adjustment)

WORK SUPPORT (LEVELIZER ADJUSTMENT)




Work Support Item List

Operation Procedure
1. Set the vehicle in unload condition. (Removal all loads in driver, passenger and trunk rooms.)
2. Touch "ADAPTIVE LIGHT" on "SELECT SYSTEM" screen.
3. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen.
4. Touch "LEVELIZER ADJUSTMENT".
5. Touch "START".
6. "ADJUSTMENT COMPLETE" will be displayed.

CAUTION: When "CAN NOT BE TESTED" is displayed, AFS control unit stops levelizer adjustment as it detected the change of height sensor signal. AFS control unit detects "DTC B2519 LEVELIZER CALIB".
Turn ignition switch OFF not to change the vehicle height. Then turn ignition switch ON and perform levelizer adjustment again.
- When "ADJUSTMENT COMPLETE" is displayed, and "NO DTC IS DETECTED" is displayed on self-diagnosis results, levelizer adjustment is completed.
- When "ADJUSTMENT COMPLETE" is displayed, and "B2514 HI SEN UNUSUAL" is displayed on self-diagnosis results, refer to LT-175, "DTC B2514 HI SEN UNUSUAL RR". B2514

7. Touch "END".
8. Turn ignition switch OFF.