Self-Diagnosis

Self-Diagnosis

OPERATION PROCEDURE
1. Turn ignition switch OFF.
2. Perform "CONSULT-II Starting Procedure". Refer to GI-38, "CONSULT-II Start Procedure". Testing and Inspection
3. Turn ignition switch ON.
4. Start engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute.
5. After stopping vehicle, with the engine running, touch "ABS", "SELF-DIAG RESULTS" in order on the CONSULT-II screen.

CAUTION: If "START (NISSAN BASED VHCL)" is touched immediately after starting engine or turning on the ignition switch, "ABS" might not be displayed in the "SELECT SYSTEM" screen. In this case, repeat the operation from step 1.

6. The self-diagnostic results are displayed. (Touch "PRINT" to print out self-diagnostic results, if necessary.)
^ Check ABS warning lamp, VDC OFF indicator lamp and SLIP indicator lamp if "NO FAILURE" is displayed. Refer to BRC-49, "Warning Lamp and Indicator Lamp Circuit". Warning Lamp and Indicator Lamp Circuit
7. Perform the appropriate inspection from display item list, and repair or replace the malfunctioning component. Refer to BRC-25, "DISPLAY ITEM LIST". Display Item List
8. Start engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute.

CAUTION: When the wheel sensor malfunctions, after inspecting the wheel sensor system, the ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp and brake warning lamp will not turn off even when the system is normal unless the vehicle is driving at approximately 30 km/h (19 MPH) or more for approximately 1 minute.