Clearing Diagnostic Trouble Codes
ERASE MEMORY1. Turn ignition switch OFF.
2. Start engine and touch "ABS", "SELF-DIAG RESULTS", "ERASE MEMORY" in order on the CONSULT-II screen to erase the diagnostic memory.
If "ABS" is not indicated, go to GI-39, "CONSULT-II Data Link Connector (DLC) Circuit". Testing and Inspection
CAUTION: If the diagnostic memory is not erased, re-perform the operation from step 4.
3. Perform self-diagnosis again, and make sure that diagnostic memory is erased.
4. Drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute as the final inspection, and make sure that the ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp and brake warning lamp turn off.
NOTE:
^ Brake warning lamp will turn on in case of parking brake operation (when switch is ON) or of brake fluid level switch operation (when brake fluid is insufficient).
^ VDC OFF switch should not stay "ON" position.