Self-Diag Result Mode

SELF-DIAG RESULT MODE
Operation Procedure
1. Perform "CONSULT-II SETTING PROCEDURE". Refer to "CONSULT-II SETTING PROCEDURE". CONSULT-II Setting Procedure
2. Start engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.





3. Stop vehicle. With engine at idle, touch "SELF-DIAG RESULTS". Display shows malfunction experienced since the last erasing operation.

NOTE: The details for "TIME" are as follow:
- "0": Error currently detected with AWD control unit.
- Except for "0": Error detected in the past and memorized with AWD control unit.
Detects frequency of driving after DTC occurs (frequency of turning ignition switch "ON/OFF").

Display Item List:

CAUTION:
^ If "CAN COMM CIRCUIT [U1000]" is displayed with other DTCs, first perform the trouble diagnosis for CAN communication line. CAN Communication Line
^ Make sure that ABS warning lamp turns OFF by driving for a minute at vehicle speed of 30 km/h (19 MPH) or more after turning ignition switch "OFF" if AWD warning lamp turns ON with system malfunction of "ABS SYSTEM [C1203]". AWD warning lamp may not turn OFF if it is normal unless ignition switch turns OFF at once and engine restarts after that.