Operating Procedure

OPERATING PROCEDURE
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)" "AIR PRESSURE MONITOR" "SELF-DIAG RESULTS".
^ If "AIR PRESSURE MONITOR" is not displayed, print the "SELECT SYSTEM" screen.

NOTE: Just after starting engine, or turning ignition switch ON, it may not be displayed even if "START (NISSAN BASED VHCL)" is touched. In this case, reconnect CONSULT-II and CONSULT-II CONVERTER.

5. The self-diagnostic results are displayed. (Touch "PRINT" to print out the self-diagnostic results if necessary) Check low tire pressure warning lamp if "NO FAILURE" is displayed.
6. Perform the appropriate inspection from the display item list, and repair or replace the malfunctioning component. Refer to "DISPLAY ITEM LIST". Display Item List