Active Test
Active TestCAUTION:
^ Do not perform active test while driving vehicle. Make sure to completely bleed air from brake system.
^ The active test cannot be performed with the ABS warning lamp, VDC indicator lamp, SLIP indicator lamp and brake warning lamp are on.
^ ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp and brake warning lamp are on during active test.
^ Erase memory of ICC system after implementing active test. Refer to ACS-34, Self-Diagnostic Function. Self-Diagnostic Function
OPERATION PROCEDURE
1. Touch START (NISSAN BASED VHCL), ABS, ACTIVE TEST in order on the CONSULT-II screen.
CAUTION: When START (NISSAN BASED VHCL) is touched immediately after starting engine or turning on ignition switch, ABS might not be displayed in the SELECT SYSTEM screen. In this case, repeat the operation from step 1.
2. Touch SELECT TEST ITEM is displayed.
3. Touch necessary test item.
4. While MAIN SIGNALS indication is inverted, touch START.
5. ACTIVE TEST screen will be displayed so perform the following test.
NOTE:
^ When active test is performed while depressing the pedal, the pedal depression amount will change. This is normal. (Only solenoid valve and ABS motor)
^ TEST IS STOPPED is displayed 10 seconds after operation start.
^ After TEST IS STOPPED is displayed, to perform test again, touch BACK and repeat step 3.
TEST ITEMS
Solenoid Valve
NOTE: The example shown is for front right wheel. The procedure for the other wheels is the same as given.
^ When performing an active test of the ABS function, select the MAIN SIGNALS for each test item. In addition, when performing an active test of the VDC/TCS function, select the item menu for each test item.
^ For ABS solenoid valve, touch UP, KEEP, and DOWN on the display screen. For ABS solenoid valve (ACT), touch UP, ACT UP, ACT KEEP and confirm that solenoid valves (IN, OUT, USV, HSV) operate as shown in the table.
ABS Motor
Touch ON and OFF on screen. Make sure motor relay and actuator relay operates as shown in table.
Note: A brief moment of ON/OFF condition occurs every 20 seconds after ignition switch turned ON. This is not malfunction because it is an operation for checking.