Lock-Up Is Not Released

Lock-up Is Not Released

SYMPTOM: The lock-up condition cannot be cancelled even after releasing the accelerator pedal.

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis. Refer to AT-90, SELF-DIAGNOSTIC RESULT MODE. Self-Diagnostic Result Mode
Refer to AT-100, Diagnostic Procedure Without CONSULT-II. Displaying & Reading Trouble Codes
Is any malfunction detected by self-diagnostic results?
YES >> Check the malfunctioning system.
NO >> GO TO 2.

2. CHECK SYMPTOM
Check again.
OK or NG
OK >> INSPECTION END
NG >> GO TO 3.

3. CHECK TCM
1. Check TCM input/output signals.
2. If NG, recheck A/T assembly harness connector terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.