AWD Warning Lamp Does Not Turn Off

AWD Warning Lamp Does Not Turn OFF Several Seconds after Engine Started

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis. Refer to TF-22, SELF-DIAG RESULT MODE. Self-Diag Result Mode
Is any malfunction detected by self-diagnosis?
YES >> Check the malfunctioning system.
NO >> GO TO 2.

2. CHECK AWD CONTROL UNIT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect AWD control unit harness connector.
3. Turn ignition switch ON. (Do not start engine.)





4. Check voltage between AWD control unit harness connector terminals and ground.





5. Turn ignition switch OFF.





6. Check voltage between AWD control unit harness connector terminals and ground.





OK or NG
OK >> GO TO 3.
NG >> Check the following. If any items are damaged, repair or replace damaged parts.
^ 10A fuse [No. 22, located in the fuse block (J/B)]
^ 10A fuse [No. 82, located in the IPDM E/R]
^ Harness for short or open between battery and AWD control unit harness connector terminal 9.
^ Harness for short or open between ignition switch and AWD control unit harness connector terminal 7.
^ Ignition switch.

3. CHECK AWD CONTROL UNIT GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect AWD control unit harness connector.





3. Check continuity between AWD control unit harness connector M10 terminals 10, 11 and ground. Continuity should exist.
Also check harness for short to ground and short to power.
OK or NG
OK >> GO TO 4.
NG >> Repair open circuit or short to ground or short to power in harness or connectors.

4. CHECK AWD CONTROL UNIT
Check AWD control unit input/output signal.
OK or NG
OK >> GO TO 5.
NG >> Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

5. SYMPTOM CHECK
Check again.
OK or NG
OK >> INSPECTION END
NG >> Perform trouble diagnosis for combination meter. Refer to DI-13, Trouble Diagnosis. Testing and Inspection