Active Test

Active Test

CAUTION:
^ Do not perform active test while driving vehicle.
^ Make sure to completely bleed air from brake system.
^ The active test cannot be performed with the ABS warning lamp, VDC indicator lamp and SLIP indicator lamp are on.

OPERATION PROCEDURE
1. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector and start engine.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which perform CAN communication.

2. Touch "START" on display.
3. Touch "ABS". If ABS is not indicated, go to GI-39, "CONSULT-II Data Link Connector (DLC) Circuit". Electrical Diagrams
4. Touch "ACTIVE TEST".
5. The test item selection screen is displayed.





6. Touch necessary test item.
7. With the "MAIN ITEM" display shown in reverse, touch "START".
8. The ACTIVE TEST screen will be displayed, so conduct the following test.

NOTE:
^ When the active test is conducted while depressing the pedal, the pedal depression amount will change, but this is normal.
^ Approximately 10 seconds after the operation is begun, "TEST STOP" will be displayed.
^ To conduct a retest after "TEST STOP" is displayed, touch "BACK" and conduct the test from the step 6.

TEST ITEM
Solenoid Valve





^ To perform active test of ABS functions, select major items for each test item. To perform active test of VDC/TCS functions, select item menu for each test item.
^ For ABS solenoid valve, touch "UP", "KEEP", and "DOWN". For ABS solenoid valve (ACT), touch "UP", "ACT UP", and "ACT KEEP". Use screen monitor to make sure solenoid valve operates as shown in Solenoid Valve Operation Chart.





ABS Motor





Touch "ON" and "OFF" on screen. Make sure motor relay operates as shown in table.