Procedure 2 Inspecting Malfunctioning Parts - CONSULT Scan Tool

Inspecting SRS malfunctioning parts by using CONSULT-II - Diagnosis mode




1. Turn ignition switch "OFF".
2. Connect "CONSULT-II" to Data link connector.




3. Turn ignition switch "ON".
4. Touch "START".




5. Touch "AIR BAG".




6. Touch "SELF-DIAG [CURRENT]".




7. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]".




If no malfunction is detected on "SELF-DIAG [CURRENT]" but malfunction is indicated by the "AIR BAG" warning lamp, go to DIAGNOSTIC PROCEDURE 6, Procedure 6 Inspecting SRS Malfunctioning Record to diagnose the following situations:

- Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
- The SRS system malfunctions intermittently.

8. Touch "PRINT".
9. Compare diagnostic codes to the CONSULT-II DIAGNOSTIC CODE CHART.
10. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
11. Turn ignition switch "OFF", then turn off and disconnect CONSULT-II and both battery cables.

CONSULT-II DIAGNOSTIC CODE CHART ("SELF-DIAG [CURRENT]") Part 1 Of 3:

CONSULT-II DIAGNOSTIC CODE CHART ("SELF-DIAG [CURRENT]") Part 2 Of 3:

CONSULT-II DIAGNOSTIC CODE CHART ("SELF-DIAG [CURRENT]") Part 3 Of 3:

12. Repair the system as outlined by the "Repair order" in CONSULT-II DIAGNOSTIC CODE CHART, that corresponds to the self-diagnosis result. For replacement procedure of component parts.
13. After repairing the system, go to DIAGNOSTIC PROCEDURE 4 Procedure 4 Final Check After Repairing SRS for final checking.
CONSULT-II can only show one seat belt pre-tensioner malfunction as self-diagnosis result at a time. Check self-diagnosis result with CONSULT-II whether other malfunctions are detected after repairing one seat belt pre-tensioner malfunction.