P1320

COMPONENT DESCRIPTION




Ignition coil & power transistor
The ignition signal from the ECM is sent to and amplified by the power transistor. The power transistor turns on and off the ignition coil primary circuit. This on-off operation induces the proper high voltage in the coil secondary circuit.




CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE
Specification data are reference values.




ECM TERMINALS AND REFERENCE VALUE
Specification data are reference values, and are measured between each terminal and (128) (ECM ground).

ON BOARD DIAGNOSIS LOGIC:

DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE

NOTE:
- If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.
- If both DTC P1320 (0201) and DTC P0340 (0101), P0335 (0802) or P1336 (0905) are displayed, perform TROUBLE DIAGNOSIS FOR DTC P0340, P0335 or P1336 first.

With Consult
1. Turn ignition switch "ON".




2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine and wait at least 4 seconds. (If engine does not run, turn ignition switch to "START" for at least 5 seconds.)
4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE".

OR

With Generic Scan Tool
Follow the procedure "With CONSULT-II" above.

EC-IGN/SG-01:

EC-IGN/SG-01 - Connector View:

EC-IGN/SG-02:

EC-IGN/SG-02:

EC-IGN/SG-03:

EC-IGN/SG-03 - Connector View:

WIRING DIAGRAM

Part 1 Of 3:

Part 2 Of 3:

Part 3 Of 3:

DIAGNOSTIC PROCEDURE

COMPONENT INSPECTION

Ignition coil with power transistor
1. Disconnect ignition coil with power transistor harness connector.







2. Check ignition coil with power transistor for resistance between terminals (3) and (2).
If NG, replace ignition coil with power transistor assembly.