P0115

Reference Data:

COMPONENT DESCRIPTION
The engine coolant temperature sensor is located near the No.2 injector. The sensor is used to detect the engine coolant temperature. The sensor modifies a voltage signal from the ECM. The modified signal returns to the ECM as the engine coolant temperature input. The sensor uses a thermistor which is sensitive to the change in temperature. The electrical resistance of the thermistor decreases as temperature increases.







ON BOARD DIAGNOSIS LOGIC




DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

With Consult
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Wait at least 5 seconds.
4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE".

OR

With Generic Scan Tool
Follow the procedure "With CONSULT-II" above.

EC-ECTS-01:

EC-ECTS-01 - Connector View:

WIRING DIAGRAM

M12,M4,M6,E66,B3,N1,M11,M48,D1,D21 Connector Views:

M3,B4,M50,B101,M49,F63,E70,E81 Connector Views:

DIAGNOSTIC PROCEDURE

COMPONENT INSPECTION

Reference Data:

Engine coolant temperature sensor
Check resistance as shown in the image.
If NG, replace engine coolant temperature sensor.