P0110

Reference Data:

COMPONENT DESCRIPTION
The intake air temperature sensor is mounted to the intake air duct The sensor detects intake air temperature and transmits a signal to the ECM.
The temperature sensing unit uses a thermistor, which is sensitive to the change in temperature. Electrical resistance of the thermistor decreases in response to the temperature rise.

ON BOARD DIAGNOSIS LOGIC:

DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE
Perform "Procedure for malfunction A" first.
If 1st trip DTC cannot be confirmed, perform "Procedure for malfunction B"

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.




Procedure for malfunction A

With Consult
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Wait at least 5 seconds.
4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE".

OR

With Generic Scan Tool
Follow the procedure "With CONSULT-II" above.







Procedure for malfunction B

CAUTION: Always drive vehicle at a safe speed.

TESTING CONDITION: This test may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

With Consult
1. Wait until engine coolant temperature is less than 90 °C (194 °F).
a. Turn ignition switch "ON".
b. Select "DATA MONITOR" mode with CONSULT-II.
c. Check the engine coolant temperature.
d. If the engine coolant temperature is not less than 90 °C (194 °F), turn ignition switch "OFF" and cool down engine.
- Perform the following steps before engine coolant temperature is above 90 °C (194 °F).
2. Turn ignition switch "ON".
3. Select "DATA MONITOR" mode with CONSULT-II.
4. Start engine and turn TCS switch "OFF".
5. Hold vehicle speed more than 70 km/h (43 MPH) for 100 consecutive seconds.
6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE".

OR

With Generic Scan Tool
Follow the procedure "With CONSULT-II" above.

EC-IATS-01:

EC-IATS-01 - Connector View:

WIRING DIAGRAM

M12,M4,M6,E66,B3,N1,M11,M48,D1,D21 Connector Views:

M3,B4,M50,B101,M49,F63,E70,E81 Connector Views:

DIAGNOSTIC PROCEDURE

COMPONENT INSPECTION

Reference Data:

Intake air temperatur sensor
Check resistance as shown in the image.
If NG, replace intake air temperature sensor.