Procedure 4 Final Check After Repairing SRS

Final Checking After Repairing SRS By Using CONSULT - Diagnosis Mode

Diagnostic Procedure 4 (With Consult):

1. After repairing SRS, connect both battery cables.
2. Connect CONSULT to Data link connector.
3. Turn ignition switch from "OFF" to "ON".

Diagnostic Procedure 4 (With Consult):

4. Touch "START".

Diagnostic Procedure 4 (With Consult):

5. Touch "AIRBAG".

Diagnostic Procedure 4 (With Consult):

6. Touch "SELF-DIAG [CURRENT]".

Diagnostic Procedure 4 (With Consult):

7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Touch "ERASE

NOTE: Touch "ERASE" to erase problem (Trouble code) retained in memory. Otherwise, diagnosis sensor unit still senses problem in memory when step 13 (Air bag warning lamp operation check) is performed. The result is confusing a new with an old problem.

Diagnostic Procedure 4 (With Consult):

If any problem code was displayed on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2 and repair malfunctioning part completely.

8. Touch "BACK" key of CONSULT.

Diagnostic Procedure 4 (With Consult):

9. Touch "SELF-DIAG [PAST]".

Diagnostic Procedure 4 (With Consult):

10. Check that no self-diagnostic failure is detected on "SELF-DIAG [PAST]".
11. Touch "BACK" key of CONSULT until SELECT SYSTEM appears, turn off CONSULT, then disconnect CONSULT
12. Turn ignition switch "OFF".
13. Go to DIAGNOSTIC PROCEDURE 1, to check SRS operation by using "AIR BAG" warning lamp with User mode.