Front Drive Axle

Front Axle Lubricant Level Inspection

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Make sure the vehicle is level.
3. Inspect the front axle for leaks. Repair as necessary.
4. Remove the engine protection shield (if equipped). Refer to Engine Protection Shield Replacement (Service and Repair).
5. Clean the area around the front axle fill plug (1).




6. Remove the front axle fill plug (1).
7. Inspect the oil level.

The oil level should be between 0-10 mm (0-0.375 in) below the fill plug opening.

8. If the level is low, add oil until the level is even with the bottom edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations (Maintenance).

Caution: Refer to Fastener Caution (Fastener Caution).

9. Install the fill plug.

Tighten the plug to 33 Nm (24 lb ft).

10. Install the engine protection shield. Refer to Engine Protection Shield Replacement (Service and Repair).
11. Lower the vehicle.