Water Pump: Service and Repair

Water Pump Replacement

Removal Procedure




1. Drain the cooling system. Refer to Cooling System Draining and Filling (Vac-N-Fill) (Service and Repair)Cooling System Draining and Filling (Static Fill) (Service and Repair).
2. Loosen the air cleaner outlet duct clamps at the following locations:

* Throttle body
* Mass airflow (MAF) intake air temperature (IAT) sensor

3. Remove the radiator inlet hose clip from the outlet duct.
4. Remove the air cleaner outlet duct.




5. Remove the radiator vent inlet hose from the radiator hose clips.




6. Reposition the inlet hose clamp at the water pump.
7. Remove the inlet hose from the water pump.
8. Remove the fan blade. Refer to Engine Coolant Fan Replacement (Engine Coolant Fan Replacement).
9. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory (Drive Belt Replacement - Accessory).




10. Reposition the outlet hose clamp at the water pump.
11. Remove the outlet hose from the water pump.




12. Reposition the surge tank outlet hose clamp at the water pump.
13. Remove the surge tank outlet hose from the water pump.




14. Reposition the heater inlet hose clamp at the water pump.
15. Remove the heater inlet hose from the water pump.




16. Remove the water pump bolts.
17. Remove the water pump and gaskets.
18. Discard the water pump gaskets.

Installation Procedure

Note: All gaskets surfaces are to be free of oil or other foreign material during assembly.




1. Install the water pump and NEW gaskets.
Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the water pump bolts.

1. Tighten the water pump bolts a first pass to 15 Nm (11 lb ft).
2. Tighten the water pump bolts a final pass to 30 Nm (22 lb ft).




3. Install the heater inlet hose to the water pump.
4. Position the heater inlet hose clamp at the water pump.




5. Install the surge tank outlet hose to the water pump.
6. Position the surge tank outlet hose clamp at the water pump.




7. Install the outlet hose to the water pump.
8. Position the outlet hose clamp at the water pump.
9. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory (Drive Belt Replacement - Accessory).
10. Install the fan blade. Refer to Engine Coolant Fan Replacement (Engine Coolant Fan Replacement).




11. Install the inlet hose to the water pump.
12. Position the inlet hose clamp at the water pump.




13. Install the engine vent inlet hose to the radiator hose clips.





Note: Align the arrow at the throttle body end of the duct with the throttle body attaching stud.

14. Install the air cleaner outlet duct.
15. Install the radiator inlet hose clip to the outlet duct.
16. Tighten the air cleaner outlet duct clamps at the following locations:

* Throttle body
* MAF/IAT sensor

Tighten the air cleaner outlet duct clamp screws to 7 Nm (62 lb in).

17. Fill the cooling system. Refer to Cooling System Draining and Filling (Vac-N-Fill) (Service and Repair)Cooling System Draining and Filling (Static Fill) (Service and Repair).