Front Door Window Glass: Service and Repair

Front Door Glass and Regulator Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the door or the related parts.

1. Remove these items:

- Front door panel Service and Repair
- Plastic cover

2. Carefully raise the glass (A) until you can see the bolts, then remove them. Carefully pull the glass out through the window slot.

NOTE: Take care not to drop the glass inside the door.






3. Disconnect the connector (A) from the regulator (B).





4. Remove the bolts and the nuts, then remove the regulator through the hole in the door.

5. Remove the bolt (A) and the screw (B) from the front lower channel (C). Pull the door weatherstrip (D) away as needed, and remove the screw (E).






6. Pull the glass run channel (A) away as needed. Pull the front lower channel (B) rearward from the corner glass seal (C), then release the upper hook (D) from the door.






7. Twist the front lower channel (A) to pass it through the gap between the door panel and the sash, then pull the channel up to remove it.





8. Remove the front lower channel from the glass run channel.

9. Remove the corner glass (A). Take care not to damage the outer weatherstrip (B).






10. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.






11. Install the glass and the regulator in the reverse order of removal, and note these items:

- Make sure the connector is plugged in properly.
- Roll the glass up and down to verify that if it moves freely without binding.
- Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
- Adjust the position of the glass as necessary Adjustments.
- Do the power window control unit reset procedure Testing and Inspection.
- When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
- Check for water leaks.
- Test-drive and check for wind noise and rattles.
- Make sure the power door locks, the power windows and the power mirror operate properly.