Removal and Replacement

Starter Removal and Installation

Removal

1. Do the 12 volt battery terminal disconnection procedure.

2. Remove the air cleaner Service and Repair.

3. M/T model: Remove the clutch hose bracket bolts (A) and nut (B).






4. CVT model: Disconnect the solenoid wire harness connector (A) and the CVT input shaft (drive pulley) speed sensor connector (B).






5. Disconnect the positive starter cable (A) and the harness connector (B) from the S terminal, then remove the heater hose bracket (C) and the harness clamps (D).

M/T model





CVT model





6. Remove the two bolts securing the starter, then remove the starter.

Installation

1. Install the starter, then tighten the starter mounting bolts (A).

M/T model





CVT model





2. Connect the positive starter cable (B) and the harness connector (C) to the S terminal, then install the heater hose bracket (D) and the harness clamps (E). Make sure the crimped side of the ring terminal is facing out.

3. M/T model: Install the clutch hose bracket bolts (A) and nut (B).






4. CVT model: Install the solenoid wire harness connector (A) and the CVT input shaft (drive pulley) speed sensor connector (B).






5. Install the air cleaner Service and Repair.

6. Do the 12 volt battery terminal reconnection procedure.