Center Console Removal / Installation

Center Console Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

SRS components are located in this area. Review the SRS component locations Locations and precautions and procedures Service and Repair before doing repair or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the seat, the dashboard, or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. M/T model: Remove the shift lever trim M/T Shift Lever Housing Replacement.

2. CVT model: Insert the appropriate trim tool to the groove (A) at front of the A/T gear position indicator panel trim (B) to detach the clips (C), then remove the A/T gear position indicator panel trim.






3. Remove the center console panel (A).

1. Pry up on the rear edge of the center console panel with the appropriate trim tool to detach the clips (B).

2. Insert the appropriate trim tool in the groove at front of the center console panel to detach the clips (C).

3. With seat heater: Disconnect the driver's seat heater switch connector (D) and the passenger's seat heater switch connector (E).





4. Remove the dashboard center lower trim Dashboard Center Trim Removal / Installation.

5. Remove the center console lid (A).

1. Remove the front console mat (B).

2. Insert the appropriate trim tool into the notch (C) of the center console lid to detach the hooks (D).





6. With seat heater: Disconnect the seat heater switch subharness connector (A).






7. Pry up on the rear edge of the parking brake cover lid (A) to detach the hooks (B), then remove it.






8. Remove the center console (A).

1. Slide both seats forward fully.

2. Remove the screws (B, C), and detach the clips (D).

3. Pry up the rear portion of the center console to detach the clip (E).

4. Pull out the front portion of the center console from the dashboard.





9. If necessary, detach the harness clips (A) and remove the bolts, then remove the center console bracket (B).






10. Install the console in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new once.
- Push the clips and the hooks into place securely.
- Make sure the wire harness is not pinched.
- Make sure each connector is plugged in properly.