Removal and Replacement

Advanced Hydraulic Booster Power Unit Replacement

NOTICE
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.

NOTE: After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.

1. Remove the cowl cover and the under-cowl panel Service and Repair.

2. Remove the brake fluid Service and Repair.

3. Remove the heat shield (A).






4. Disconnect the brake line (A) from the power unit (B).





5. Disconnect the suction hose (C) from the brake line (D).

6. Disconnect the power unit 2P connector (A), and remove the clip (B).





7. Remove the power unit (C) with the bracket (D) from the frame.

8. Separate the power unit (A) and the bracket (B), and remove the suction hose (C).





9. Install the power unit in the reverse order of removal.

10. Do the normal brake system bleeding (except the servo unit and the power unit).

11. Do the servo unit and power unit system bleeding.