Rear Door Window Glass: Service and Repair

Rear Door Glass and Regulator Replacement

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the door or the related parts.

1. Remove these items:

- Rear door panel Service and Repair
- Rear door rear sash trim
- Rear door glass outer weatherstrip Service and Repair
- Plastic cover

2. Carefully raise the glass (A) until you can see the bolts, then remove them. Remove the glass from the regulator (B) and carefully lower the glass.

NOTE: Take care not to drop the glass inside the door.






3. Remove the bolts (A, B) from the rear lower channel (C), then remove the collar (D). Pull the door weatherstrip (E) away as needed, and remove the screw (F).






4. Pull the glass run channel (A) away as needed. Pull the rear lower channel (B) forward from the quarter glass seal (C), then release the upper hook (D) from the door. Remove the rear lower channel from the rear door glass (E), then pull the channel up to remove it.





5. Remove the rear lower channel from the glass run channel.

6. Carefully pull the glass (A) out through the window slot.

NOTE: Take care not to drop the glass inside the door.






7. Remove the quarter glass (A). Take care not to damage the outer weatherstrip (B).






8. Disconnect the connector (A) from the regulator (B).





9. Remove the bolts (C, D), then remove the regulator through the hole in the door.

10. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.






11. Install the glass and the regulator in the reverse order of removal, and note these items:

- Make sure the connector is plugged in properly.
- Roll the glass up and down to verify that if it moves freely without binding.
- Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
- Adjust the position of the glass as necessary Adjustments.
- Do the power window control unit reset procedure Testing and Inspection.
- When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
- Check for water leaks.
- Test-drive and check for wind noise and rattles.
- Make sure the power door locks and the power windows operate properly.