Cylinder Head Cover Removal

Cylinder Head Cover Removal

Front

1. Remove the intake manifold.

2. Remove the three ignition coils from the front cylinder head.

3. Disconnect the EGR valve connector (A), the front secondary HO2S connector (B), the front A/F sensor 2 connector (C), the rocker arm oil control solenoid A (Bank 2) connector (D), the front rocker arm oil pressure switch connector (E) and the harness clamp (F) securing the harness holder, and remove the dipstick (G).





4. Remove the bolt (H) securing the harness holder.

5. Remove the front cylinder head cover.






Rear

1. Remove the strut brace Frame Brace Replacement.

2. Remove the intake manifold.

3. Remove the three ignition coils from the rear cylinder head.

4. Remove the drive belt:

- '10 model Service and Repair

5. Remove the power steering pump and the power steering hose bracket with its hoses connected.

6. Remove the harness holder mounting bolts (A) and the engine ground cable (B).





7. Disconnect the three injector connectors (C) and the two harness clips (D).

8. Remove the harness (E) from the upper cover.

9. Disconnect the rear rocker arm oil pressure switch connector (A), the rocker arm oil control solenoid B (Bank 1) connector (B), the rocker arm oil control solenoid A (Bank 1) connector (C), the rear A/F sensor connector (D), the rear secondary HO2S connector (E), and the harness clamps (F), then remove the harness holder (G).





10. Disconnect the breather hose (H).

11. Remove the rear cylinder head cover.