Cylinder Head Cover Removal (J35Z3 Engine)

Cylinder Head Cover Removal

Front

1. Remove the intake manifold. Intake Manifold Removal and Installation

2. Remove the three ignition coils from the front cylinder head. Service and Repair

3. Disconnect the exhaust recirculation (EGR) valve connector (A), the front secondary heated oxygen sensor 2 (secondary HO2S) connector (B), the front air fuel ratio (A/F) sensor 2 connector (C), and the harness clamp (D) securing the harness holder, and remove the dipstick (E).

4. Remove the bolt (F) securing the harness holder.






5. Remove the front cylinder head cover.






Rear

1. Remove the intake manifold. Intake Manifold Removal and Installation

2. Remove the three ignition coils from the rear cylinder head. Service and Repair

3. Remove the drive belt. Drive Belt Replacement (J35Z3 Engine)

4. Remove the power steering (P/S) pump and the P/S hose bracket Cylinder Head Removal (J35Z3 Engine) with its hoses connected.

5. Remove the harness holder mounting bolts (A) and the engine ground cable bolt (B).

6. Disconnect the three injector connectors (C) and the two harness clips (D).

7. Remove the engine ground cable (E) and disconnect the breather hose (F).

8. Remove the harness (G) from the upper cover.






9. Remove the rear cylinder head cover.