DTC 61-2x

DTC 61-2x ("x" can be 0 thru 9 or A thru F): Short in the Driver's Seat Belt Buckle Switch

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information.

1. Clear the DTC memory.
2. Turn the ignition switch to LOCK (0), then wait for 10 seconds.
3. Turn the ignition switch to ON (II), then buckle and unbuckle the driver's seat belt several times.
4. Read the DTC.

Is DTC 61-2x indicated?

YES - Go to step 5.

NO - Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. Troubleshooting Intermittent Failures If another DTC is indicated, troubleshoot the DTC.

5. Turn the ignition switch to LOCK (0).
6. Disconnect the SRS floor wire harness 2P connector from the driver's seat belt buckle switch.






7. Turn the ignition switch to ON (II).
8. Read the DTC.

Is DTC 61-2x indicated?

YES - Short to ground in the SRS floor wire harness; replace the SRS floor wire harness.

NO - Faulty driver's seat belt buckle switch; replace the driver's seat belt buckle assembly.