DTC 21-1x
DTC 21-1x (21-10 to 21-19, 21-1A to 21-1F): Open in Driver's Seat Belt TensionerDTC 21-2x (21-20 to 21-29, 21-2A to 21-2F): Increased Resistance in Driver's Seat Belt Tensioner
Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead F 07XAZ-SZ30100
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on, and is DTC 21-1x or 21-2x indicated?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Troubleshooting Intermittent Failures If another DTC is indicated: go to the DTC Troubleshooting Index. Diagnostic Trouble Code Descriptions
3. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 4P connector (A) from the driver's seat belt tensioner.
5. Connect the SRS inflator simulator (2 ohms connectors) and simulator lead F to the floor wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTC 21-1x or 21-2x indicated?
YES - Go to step 9.
NO - Open or increased resistance in the driver's seat belt tensioner; replace the driver's seat belt.
9. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
10. Disconnect the front passenger's seat belt tensioner connector.
11. Disconnect SRS unit connector B (28P) from the SRS unit.
12. Check resistance between the No. 1 and the No. 2 terminals of SRS unit connector B (28P). There should be 2.0 - 3.0 ohms.
Is resistance as specified?
YES - Faulty SRS unit or poor connection at SRS unit connector B (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit.
NO - Open or increased resistance in the floor wire harness; replace the floor wire harness.