Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Pulley Removal and Installation
Special Tools Required
^ Holder handle 07JAB-001020A
^ Crankshaft pulley holder 070AB-RJA0100
^ Socket, 19 mm 07JAA-001020A, or a commercially available 19 mm socket

Removal
1. Raise the vehicle on the hoist to full height.
2. Remove the right front wheel.
3. Remove the splash shield.





4. Remove the A/C compressor belt.
5. Hold the pulley with the holder handle (A) and crankshaft pulley holder (B).





6. Remove the bolt with a heavy duty 19 mm socket (C) and breaker bar, then remove the crankshaft pulley.

Installation
1. Remove any oil or clean the pulleys (A), crankshaft (B), bolt (C), and washer (D). Lubricate new engine oil as shown.





2. Install the crankshaft pulley, and tighten the bolt. Do not use an impact wrench.
- 1 Hold the pulley with the holder handle (A) and crankshaft pulley holder (B), then tighten the bolt to 64 Nm (6.5 kgf-m, 47 ft. lbs.) with a torque wrench and a 19 mm socket (C).
- 2 Mark (D) the bolt head and crankshaft pulley as shown, then tighten the bolt an additional 60° (The mark on the bolt head lines up with the mark on the crankshaft pulley).








3. Install the A/C compressor belt.
4. Install the splash shield.
5. Install the right front wheel.