DTC 24-11

DTC 21-11: Right-front Magnetic Encoder Malfunction (Corrugated Missing)
DTC 22-11: Left-front Magnetic Encoder Malfunction (Corrugated Missing)
DTC 23-11: Right-rear Pulser Malfunction (Corrugated Missing)
DTC 24-11: Left-rear Pulser Malfunction (Corrugated Missing)
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS. Turn the ignition switch OFF, then ON (II) again.
3. Test-drive the vehicle. Drive the vehicle speed at 13 mph (20 km/h) or more, and go a distance of 6.2 miles (100 m) or more.
4. Check for DTCs with the HDS.
Is DTC 21-11, 22-11, 23-11, and/or 24-11 indicated?
YES - Go to step 5.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the wheel sensor.
5. Turn the ignition switch OFF.





6. Inspect the appropriate magnetic encoder, or pulser (see table).
Is the magnetic encoder surface, or the pulser gears OK?
YES - Replace the wheel bearing or wheel bearing unit:
^ Front: Replace the front wheel bearing.
^ Rear: Replace the rear wheel bearing.
NO - Clean off dust or dirt from the appropriate magnetic encoder surface on the wheel bearing, or the wheel bearing unit, or replace the appropriate pulser gears for a chipped or damaged tooth, then go to step 1 and recheck.