DTC 14-11

DTC 12-11: Right-front Wheel Sensor Electrical Noise or Intermittent Interruption
DTC 14-11: Left-front Wheel Sensor Electrical Noise or Intermittent Interruption
DTC 16-11: Right-rear Wheel Sensor Electrical Noise or Intermittent Interruption
DTC 18-11: Left-rear Wheel Sensor Electrical Noise or Intermittent Interruption
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS. Turn the ignition switch OFF, then ON (II) again.
3. Test-drive the vehicle.
4. Check for DTCs with the HDS.
Is DTC 12-11, 14-11, 16-11, and/or 18-11 indicated?
YES - Troubleshooting DTC 12-12, 14-12, 16-12, and/or 18-12.
NO - Go to step 5.
5. Turn the ignition switch OFF.
6. Turn the ignition switch ON (II).
7. Clear the DTC with the HDS.
8. Test-drive the vehicle.
9. Check for DTCs with the HDS.
Is DTC 12-11, 14-11, 16-11, and/or 18-11 indicated?
YES - Go to step 10.
NO - If any DTCs are indicated, go to the indicated DTCs troubleshooting. If DTC is not indicated, intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the wheel sensor.
10. Turn the ignition switch OFF.
11. Remove the appropriate wheel sensor.





12. Check the appropriate wheel sensor.
Is there O-ring biting, and inclination the wheel sensor?
YES - Reinstall the wheel sensor, and check the mounting position.
NO - Check for loose terminals in the VSA modulator-control unit 37P connector. If necessary, substitute a known-good VSA modulator-control unit and retest. If DTCs are not indicated, replace the VSA modulator-control unit.