P0796
DTC P0796: CVT Start Clutch Pressure Control Valve Stuck OFF2004-2005 AT-PZEV Models
NOTE: Record all freeze data and review General Troubleshooting Information before you troubleshoot.
1. Clear the DTC with the HDS.
2. Set the parking brake, and block the front wheels securely.
3. Warm up the engine until the engine coolant temperature reaches 176°F (80°C).
4. Fully press the brake pedal, and shift to the D position.
5. While pressing the brake pedal fully, and press the accelerator for 6 - 8 seconds at full throttle.
6. Measure the stall speed rpm in the D position.
Does the engine speed exceed 3,500 rpm?
YES- Go to step 7.
NO- Intermittent failure, the system is OK at this time.
7. Run the engine at 4,000 rpm for 4 seconds, and check that DTC P0796 recurs.
Is DTC P0796 indicated?
YES- CVT start clutch pressure control valve may be stuck OFF. Replace the CVT start clutch pressure control valve, then go to step 8.
NO- Intermittent failure, the system is OK at this time.
8. Clear the DTC with the HDS.
9. Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data.
10. Check that DTC P0796 recurs.
Is DTC P0796 indicated?
YES- Replace the transmission assembly.
NO- The problem has been corrected.