P0135

DTC P0135: Primary HO2S (Sensor 1) Heater Circuit Malfunction

NOTE: Information marked with an asterisk (*) applies to the D17A2 engine.

1. Reset the ECM/PCM.
2. Start the engine.

Is DTC P0135 indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. check for poor connections or loose terminals at the primary HO2S (Sensor 1) and the ECM/PCM.

3. Turn the ignition switch OFF.
4. Disconnect the primary HO2S (Sensor 1) 4P connector.




5. At the primary HO2S side, measure resistance between primary HO2S (sensor 1) 4P connector terminals No.3 and No.4.

Is there 10 - 40 Ohms ?

YES - Go to step 6.

NO - Replace the primary HO2S (Sensor 1).




6. Check for continuity between body ground and primary HO2S (Sensor 1) 4P connector terminals No.3 and No.4 individually.

Is there continuity?

YES - Replace the primary HO2S (Sensor 1).

NO - Go to step 7.

7. Turn the ignition switch ON (II).




8. Measure voltage between primary HO2S (Sensor 1) 4P connector terminals No.3 and No.4.

Is there battery voltage?

YES - Go to step 9.

NO - Go to step 12.

9. Turn the ignition switch OFF.
10. Disconnect ECM/PCM connector A (31P).




11. Check for continuity between ECM/PCM connector terminal A1 and body ground.

Is there continuity?

YES - Repair short in the wire between the ECM/PCM (A1) and the primary HO2S (Sensor 1).

NO - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.




12. Measure voltage between primary HO2S (Sensor 1) 4P connector terminal No.3 (No.4)* and body ground.

Is there battery voltage?

YES - Go to step 13.

NO - Repair open in the wire between the primary HO2S (Sensor 1) and No.4 ACG (10A) fuse.

13. Turn the ignition switch OFF.
14. Reconnect the primary HO2S (Sensor 1) 4P connector
15. Disconnect ECM/PCM connector A (31P).
16. Turn the ignition switch ON (II).




17. Measure voltage between ECM/PCM connector terminal A1 and A5.

Is there 0.1 V or less?

YES - Repair open in the wire between the ECM/PCM (A1) and the primary HO2S (Sensor 1).

NO - Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM, then recheck. If the symptom/indication goes away with a known-good ECM/PCM, replace the original ECM/PCM.