Camshaft Roller Follower

Camshaft Roller Follower





Removal

1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Vehicle Jacking and Lifting. Failure to follow the instructions may result in serious personal injury.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the valve covers. For additional information, refer to Valve Cover - RH Valve Cover - RH or Valve Cover - LH Valve Cover - LH.

3. Position the piston of the cylinder being repaired at the bottom of the stroke.

4. Install the Valve Spring Compressor Spacer between the valve spring coils to prevent valve stem seal damage.





5. Using the Valve Spring Compressor, compress the valve springs and remove the camshaft roller followers.





Installation

1. Using the Valve Spring Compressor, compress the valve spring and install the camshaft roller followers.





2. Remove the Valve Spring Compressor from between the valve spring.





3. Install the valve covers. For additional information, refer to Valve Cover - RH Valve Cover - RH or Valve Cover - LH Valve Cover - LH.

4. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Vehicle Jacking and Lifting. Failure to follow these instructions may result in serious personal injury.

If equipped with a fire suppression system, repower the system.