K: Speedometer Reads 0 km/h (MPH) at All Times

Pinpoint Test K - Speedometer Reads 0 KM/H (MPH) At All Speeds

K1 - Check Speedometer Reading

- Test drive vehicle above 8 km/h (5 mph) and 00k for:
- Speedometer reading
- Odometer changing
- Verify that odometer advances when vehicle is driven torward.

Does odometer advance with no speed indication?

YES REPLACE electronic instrument cluster. AFFIX odometer sticker to door pillar. RESTORE vehicle. RETEST system.
NO GO to K2.

K2 - Check Speed Control

- Test drive vehicle above 48 km/h (30 mph), check speed control operation.

Did speed control operate properly?

YES GO to K3.
NO GO to K4.

K3 - Check Continuity

- Disconnect battery ground cable.
- Disconnect connectors C1 and C2 at electronic instrument cluster.
- Disconnect vehicle speed sensor.
- Check continuity in connector pin C1-12, circuit 679 (GY/BK) and continuity to ground in connector pin C1-8, circuit 676 (PK/O).

Is continuity present?

YES REPLACE electronic instrument cluster. AFFIX odometer sticker to door pillar. RESTORE vehicle. RETEST system.
NO SERVICE respective circuit. RESTORE vehicle. RETEST system.

K4 - Check Vehicle Speed Sensor

- Disconnect vehicle speed sensor.
- Measure resistance across vehicle speed sensor.

Is resistance between 200-300 ohms?

YES CHECK circuits 679 (GY/BK) and 676 (PK/O) for continuity. If circuits OK, CHECK driven gear and retainer clip. REPLACE if necessary. RESTORE vehicle. RETEST system.
NO REPLACE vehicle speed sensor. RESTORE vehicle. RETEST system.