IGNA7 - Check VBAT at Coil

^ Key OFF.

^ Connect diagnostic cable coil tee to vehicle harness; do not connect diagnostic cable to coil.

^ Key ON.

^ DVOM on DC volt scale.

^ Measure voltage between Pin 2 (VBAT C) and Pin 7 (BAT-).

^ Is voltage greater than 10 volts DC?

YES -- GO to IGNA8. IGNA8 - Check For Coil (-) Signal

NO -- Service power open to coil in harness or connector. Remove all test equipment. Reconnect all components. Clear continuous memory. Rerun quick test.