IGNA22 - Check PIP Signal at PIP Sensor

^ Key OFF.

^ Connect diagnostic cable PIP sensor tee to vehicle harness.

^ DVOM on DC volt scale.

^ Key ON.

^ Measure the voltage between Pin 34 (PIP) and Pin 7 (BAT-).

^ Is the voltage greater than 9 volts DC?

YES -- Replace distributor. PIP open in PIP sensor Remove all test equipment. Reconnect all components. Clear continuous memory. Rerun quick test.

NO -- Service PIP open in harness between PCM and PIP sensor. Remove all test equipment. Reconnect all components. Clear continuous memory. Rerun quick test.