Power Steering Pump - Installation

SRT





1. Align pump (1) with mounting holes on engine.
2. Install three pump mounting bolts (2) through access holes in pulley. Tighten bolts to 28 Nm (21 ft. lbs.).






NOTE: Always use a NEW O-ring on the end of the pressure hose.

3. Lubricate NEW O-ring on end of pressure hose with clean power steering fluid.
4. Install pressure hose (2) to pump (3). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).
5. Install return hose (1) to power steering pump (3) and install clamp securing hose in place.
6. Install serpentine drive belt. Serpentine Accessory Drive Belt - Installation





7. While sliding the air duct onto the throttle body, lower the air cleaner housing (5) into position and align the locating pin on the bottom of the housing.
8. Install the air cleaner housing retaining bolt (4) and tighten to 5 Nm (44 in. lbs.).
9. Install the makeup air hose (3) at the air cleaner housing.
10. Connect the intake air temperature sensor electrical connector (2).
11. Position the air duct retaining clamp (1) at the throttle body and tighten to 3 Nm (30 in. lbs.).





12. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
13. Fill and bleed power steering system. Service and Repair