Starter - Installation

6.4L






NOTE: Do not allow the starter motor to hang from wire harness.

1. Position the starter (5) into transmission but do not install bolts.
2. Connect the solenoid harness connector to starter motor (snaps on).
3. Position the battery cable to solenoid stud and install the battery cable eyelet nut.Tighten to 11 Nm (8 ft. lbs.).
4. Install the lower starter mounting retainer (4).
5. Install the two starter stub mounting bolts (3).
6. Tighten all three starter mounting retainers (3) and (4) to 25 Nm (19 ft. lbs.)
7. Install the heat shield (2).
8. Install the shield nuts (1).Tighten to 18 Nm (13 ft. lbs.)
9. Lower the vehicle.
10. Connect negative battery cable.