Active Damping Control Module (ADCM) Verification Test

ADCM VERIFICATION TEST
ADCM VERIFICATION TEST
1. Turn the ignition off.
2. Connect all previously disconnected components and connectors.
3. Verify all accessories are turned off and the battery is fully charged.
4. Verify that the ignition is on, with the scan tool, erase all Diagnostic Trouble Codes (DTCs) from All modules. Start the engine and allow it to run for two minutes and fully operate the system that was indicating the failure.
5. Turn the ignition off and wait five seconds. Turn the ignition on and using the scan tool, read DTCs from all modules.
6. If any Diagnostic Trouble Codes are present, Testing and Inspection and perform the diagnostic procedure.
7. If there are no DTCs present after turning ignition on, road test the vehicle for at least five minutes.
- Test drive the vehicle by turning the vehicle left or right in a curving manner at a speed above 25 km/h (15 mph).

8. Again, with the scan tool read DTCs. If any DTCs are present, Testing and Inspection for the diagnostic procedure and troubleshoot the new or recurring DTC.
9. If there are no Diagnostic Trouble Codes (DTCs) present, and the customer's concern can no longer be duplicated, the repair is complete.

Are any DTCs present or is the original concern still present?

Yes

- Repair is not complete, perform the appropriate diagnostic procedure. Testing and Inspection

No

- Repair is complete.