Power Steering Pump - Removal

SRT





1. Disconnect and isolate battery negative cable (2) from battery post.
2. Siphon power steering fluid from pump reservoir.





3. Loosen the air duct retaining clamp (1) at the throttle body.
4. Disconnect the intake air temperature sensor electrical connector (2).
5. Remove the makeup air hose (3) at the air cleaner housing.
6. Remove the air cleaner housing retaining bolt (4).
7. While lifting up the air cleaner housing (5), slide the air duct off the throttle body and remove the air cleaner housing from the vehicle.
8. Remove serpentine drive belt. Serpentine Accessory Drive Belt - Removal





9. Remove hose clamp, then supply hose (1) from pump (3).
10. Unthread tube nut, then remove pressure hose (2) from pump (3).





11. Remove three pump mounting bolts (2) through access holes in pulley (3).
12. Remove pump (1) from engine.
13. If pulley needs removal, Power Steering Pump Pulley - Removal.