Clutch Disc - Installation

INSTALLATION






NOTE: If flywheel is replaced or removed apply thread sealer to the flywheel retaining bolts. This will prevent engine oil from leaking onto the clutch.

1. Insert Clutch Tool 10018 (1) into pilot bearing.
2. Install independent clutch disc over clutch tool up against flywheel.
3. Install pressure plate assembly (2) over clutch tool up against flywheel and onto the dowel pins (3).
4. If new clutch or flywheel is installed, align cover balance spot as close as possible to flywheel balance orange spot.
5.
6. Tighten new pressure plate bolts a few turns at a time in a star pattern until bolts are seated. Then tighten bolts in star pattern to 75 Nm (55 ft. lbs.). Remove clutch disc alignment tool.
7. Install clutch housing and transmission.